grasshopper2 Rhinorhino3d.com
ComponentAuto-generatedSurface
Patch Edges
00000000-e32c-43ee-9990-2f689caa5b9d
object previewBoundary inputlist · requiredCurves forming a closed boundary. Curves which coincide with naked edges of the surfaces inherit the continuity, other curves only constrain position.Surfaces inputlist · requiredSurfaces surrounding the gap.Continuity inputinteger · item · requiredContinuity between the patch and the surfaces.Patch outputitemPatch surface.

⚠️ This content is auto-generated.

Create a patch surface which fills the gap between surfaces, with tangency or curvature continuity along their edges.

Input parameters:

  1. Bn → Curves forming a closed boundary. Curves which coincide with naked edges of the surfaces inherit the continuity, other curves only constrain position.
  2. Sf → Surfaces surrounding the gap.
  3. Cn → Continuity between the patch and the surfaces.
    • 0 → Position
    • 1 → Tangency
    • 2 → Curvature
  4. Ic → Optional curves inside the boundary which the patch must pass through.
  5. Ip → Optional points inside the boundary which the patch must pass through.
  6. Mt → Patch domain method.
    • 0 → Projected
    • 1 → Molded
    • 3 → MultiBlend
  7. Sp → Initial number of spans in both directions. More spans are added automatically where needed.
  8. Dg → Degree of the patch surface in both directions.
  9. Bn → Balance between minimising the change in bending (zero) and the bending itself (one). Zero yields the smoothest and fastest patches.
  10. Rt → Rotation of the patch uv directions.
  11. Is → Optional non-rational surface to start the patch from.
  12. Pe → If true, the boundary of the initial surface is kept fixed.

Output parameters:

  1. Pa → Patch surface.