grasshopper2
Rhinorhino3d.com
ComponentAuto-generatedSurface
SubD From Surface
00000000-6b78-4e6f-9f99-107c01b9baaa
object preview
This page was generated from the component’s built-in descriptions. An in-depth article has not been written for it yet.

Convert a NURBS surface into a SubD surface.

Input parameters:

  1. Sf → Surface to convert.
  2. Cr → Sharp corner state. When true, the corner points of open surfaces will remain sharp.
  3. Fi → Fitting state. When true, a SubD-friendly NURBS surface will be fitted through the input surface if required.

Output parameters:

  1. Sd → Subdivision surface based on NURBS input.